Alterações no passo nº 4
Edição por Adriana Zwink —
Edição aprovada por Adriana Zwink
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* black] Grab the pull tab with your fingers and ''slowly'' pull it away from the battery, toward the bottom of the iPhone. |
|---|---|
| - | [* black] Repeat the previous procedure on the two remaining pull tabs. |
| - | [* icon_note] If the adhesive breaks off underneath the battery and can't be retrieved, apply a few drops of high concentration (over 90%) isopropyl alcohol under the edge of the battery in the area of the broken adhesive strip(s). |
| - | [* black] Wait about one minute for the alcohol solution to weaken the adhesive. |
| - | [* black] Use the flat end of a spudger to gently lift the battery. |
| - | [* icon_caution] Don't try to forcefully lever the battery out. If needed, apply a few more drops of alcohol to further weaken the adhesive. Never deform or puncture the battery with your pry tool. |
| + | [* black] Grab the second pull-tab with your fingers and pull it away from the battery, toward the bottom of the iPhone. |
| + | [* black] Follow the same procedure as with the previous strip: don't press down on the battery, keep the strip flat and unwrinkled, and pull at a low angle. |
| + | [* black] If the adhesive strip breaks off, try to retrieve it using your fingers or blunt tweezers, and continue pulling—but do not pry under the battery. |
| + | [* icon_note] If the adhesive breaks off underneath the battery and can't be retrieved, continue with the next step. |